- 您现在的位置：买卖IC网 > Sheet目录536 > XC09-038PKT-RA (Digi International/Maxstream)MODEM RF 900MHZ RS232/485 W/ACC
9XCite ‐ PKG ‐ R? ? RS ‐ 232/485 ? RF ? Modem ? – ? Product ? Manual ? v2.1 ? [2007.01.04]
FH (Force Wake-up Initializer) Command
<AT Command: Sleep (Low Power)> FH Command is used to force a Wake-up Initializer to be sent
on the next transmission. WR (Write) Command does not need to be issued with FH Command.
Use only with cyclic sleep modes active on remote modems.
AT Command: FH
FL (Software Flow Control) Parameter
<Non-AT Settable Parameter: Serial Interfacing>
FL Parameter is used to adjust serial flow control.
Hardware flow control is implemented with the
XCite Radio Modem as the CTS pin (which regu-
lates when serial data can be transferred to the
radio modem). FL Parameter can be used to allow
software flow control to also be enabled. The XON
Parameter Ranges: 0 - 1
Parameter
0
1
Configuration
No Software Flow
Control
Use Software Flow
Control
character to use is 0x11 ("17" decimal). The XOFF
character to use is 0x13 ("19" decimal).
HP (Channel) Command
<AT Command: Networking> HP Command is
used to set the radio modem channel number. A
channel is one of three layers of addressing avail-
able to the XCite Radio Modem. In order for radio
modems to communicate with each other, the
modems must have the same channel number
since each channel uses a different hopping
sequence or single frequency. Different channels
can be used to prevent modems in one network
from listening to transmissions of another.
The XCite Radio Modem can operate both in Hop-
ping and Single Frequency Channel Modes.
Switching between Single Channel and Hopping
Modes can only be done only using the "Function
Set" dropdown list on the "Modem Configuration"
tab of the X-CTU Software
A "Hopping Channel" is a channel comprised of a
group of frequencies. When in Hopping Channel
Mode, the radio modem hops between the fre-
quencies them when transmitting data. This
option utilizes FHSS (Frequency Hopping Spread
Spectrum) technology. This option helps bolster
security in wireless data communications and also
makes the system less prone to interference.
The 25 center frequencies available in Single Fre-
quency Channel Mode are spaced 300 KHz apart.
Since each channel occupies a 500 KHz band-
width, adjacent channels therefore overlap. If
modems are used in the same vicinity but on dif-
ferent channels, the channels used should occupy
every other channel at a minimum separation. If
channels used on different radio modems can be
separated more they should be. This will provide
for more isolation and less interference.
? ? 2007 ? MaxStream, ? Inc.
Default Parameter Value: 0
Number of bytes returned: 1
AT Command: ATHP
Parameter Range (Hopping Mode): 0 - 6
Parameter Range (Single Frequency Mode):
0 - 0x18 [refer to rows below]
Parameter Frequency (MHz)
0x00 910.5
0x01 910.8
0x02 911.1
0x03 911.4
0x04 911.7
0x05 912.0
0x06 912.3
0x07 912.6
0x08 912.9
0x09 913.2
0x0A 913.5
0x0B 913.8
0x0C 914.1
0x0D 914.4
0x0E 914.7
0x0F 915.0
0x10 915.3
0x11 915.6
0x12 915.9
0x13 916.2
0x14 916.5
0x15 916.8
0x16 917.1
0x17 917.4
0x18 917.7
Default Parameter Value: 0
Number of bytes returned: 1
????? 26
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
XC0900A-03S
COUPLER 90DEG 811-1000MHZ 3DB
XC1900A-03S
COUPLER 90DEG 1700-2000MHZ 3DB
XC2401A8167R-G
IC GPS LNA 1.6GHZ USPN-4B02
XC2404A816UR-G
IC GPS LNA 1.6GHZ USP-8A01
XE112
LAMP T3-1/4 WITH XE GAS WHITE
XE1203SKC868XE2
KIT STARTER FOR XE1203 868MHZ
XE1205SKC868XE1
KIT STARTER FOR XE1205 868MHZ
XE1283I076TRLF
IC TXRX UHF LOW POWER 72-LFBGA
相关代理商/技术参数
XC09-038WNC
功能描述:射频模块 9XCite 4mW transcei e antenna 38400 bps
RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
XC09-038WNI
功能描述:射频模块 9XCite 4mW transcei e antenna 38400 bps
RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
XC-09-201-S
制造商:FLOYD BELL 功能描述:Alarm, Piezoelectric, 82 dBA to 103 dBA @ 2 Ft.,Extra Loud Continuous, 30-120VAC
XC-09-212-S
制造商:FLOYD BELL 功能描述:EXTRA LOUD CONTINUOUS, PANEL MOUNT CASE AND QUICK CONNECT BLADES WITH SCREWS TER
XC-09-212-SR
制造商:FLOYD BELL 功能描述:Alarm, Piezoelectric, 82 dBA to 103 dBA @ 2 Ft., Extra Loud Continuous, 2-12VDC
XC-09-212-W
制造商:FLOYD BELL 功能描述:EXTRA LOUD CONTINUOUS; PANEL MOUNT CASE AND WIRES TERMINATION
XC-09-301-S
制造商:FLOYD BELL 功能描述:Alarm, Piezoelectric, 82 dBA to 103 dBA @ 2 Ft.,Extra Loud Continuous,130-220VAC
XC-09-330-Q
制造商:FLOYD BELL 功能描述:EXTRA LOUD CONTINUOUS; PANEL MOUNT CASE AND QUICK CONNECT BLADES TERMINATION